02-19-2016, 10:05 PM
I just loaded and ran the new test sketches. I monitored the power bar serial output. nothing was displayed.
display board:
Initializing sd card...
SUCCESS - sd card initialized.
Wait 5 seconds for test to begin
Serial1 Sent Signal to Power Bar
ethernet board:
Initializing sd card...
SUCCESS - sd card initialized.
I have a soldering iron and will solder. :)
display board:
Initializing sd card...
SUCCESS - sd card initialized.
Wait 5 seconds for test to begin
Serial1 Sent Signal to Power Bar
ethernet board:
Initializing sd card...
SUCCESS - sd card initialized.
I have a soldering iron and will solder. :)