02-18-2016, 05:26 PM
Rob,
I downloaded the sketches and ran them. The serial port was set to 9600 baud
I have posted the serial output for each sketch below:
ehternet_test:
Initializing sd card...
SUCCESS - sd card initialized.
Display_Test:
Initializing sd card...
SUCCESS - sd card initialized.
Wait 5 seconds for test to begin
Serial1 Sent Signal to Power Bar
Powerbar_Test:
nothing was displayed
I made sure the other two processors were loaded with the Robo tank software and were running.
What do you think?
I downloaded the sketches and ran them. The serial port was set to 9600 baud
I have posted the serial output for each sketch below:
ehternet_test:
Initializing sd card...
SUCCESS - sd card initialized.
Display_Test:
Initializing sd card...
SUCCESS - sd card initialized.
Wait 5 seconds for test to begin
Serial1 Sent Signal to Power Bar
Powerbar_Test:
nothing was displayed
I made sure the other two processors were loaded with the Robo tank software and were running.
What do you think?