Dom59 I found the sketch you were referring to called DUE_EEPROM_Defaults. I ran it but still have the same problem, no communication between the display and the power bar. rott, i'm not sure what you mean by "and to make sure your plugging your usb cable in to the usb closest to the power plug on the board" are you referring to the cable between the power bar and the ethernet board?
rott, I think your right the eprom_clear is for the mega only.
OK interesting development, I have the internet page for my Robo-Tank up. I just tried pressing the feed fish icon on the display , When I did the internet page updated showing all the pumps off. After 6 minutes the screen went from feeding mode to regular mode and the internet page updated showing the pumps back on. So there is some communication going on even though I get a red plug in the upper right hand corner and I can't sync the system.
rott, I think your right the eprom_clear is for the mega only.
OK interesting development, I have the internet page for my Robo-Tank up. I just tried pressing the feed fish icon on the display , When I did the internet page updated showing all the pumps off. After 6 minutes the screen went from feeding mode to regular mode and the internet page updated showing the pumps back on. So there is some communication going on even though I get a red plug in the upper right hand corner and I can't sync the system.