Hi Rob,
Uploaded the test sketch this morning.
I will show you what I did:
- checked Arduino IDE version 1.6.5, used document "First Time Proframming Guide"
- closed Arduino program
- put the files "platform.txt" and "RingBuffer.h" into place again according to the FTPG
- removed the complete "libraries" folder in documents/arduino
- copied the complete "libraries" folder from v3.6 unzipped to documents/arduino
- overwritten the "TimeAlarms" folder with the one you mailed me
- copied the calibration file for my display (CPLD 7 inch) to Arduino/libraries/Utouch and have overwritten the one already there
- uncommented correct display in the DisplayV2_OOP.ino you've send me
- removed all files from both the SD cards
- copied all original files from v3.6 unzipped, controller and display, to SC cards
- uploaded original v3.6 sketch to controller
- uploaded the DisplayV2_OOP.ino to display
I haven't touched the controller sketch and the only thing modified in the display sketch (DisplayV2_OOP.ino) was setting the display right.
I also left the original pump names as they are, just to be sure.
I changed the pump 4 schedule to 10:15 again, checked the others but did not change any further settings.
After that I pressed "resume".
Hopefully turned on the light in the cabinet to see whether dosing happens...
As you can see: NO dosing at 10:15...
Finally I dosed manually (pump 4).
It's a little later now, made some new pics to show you my settings.
These are the settings of pump 4:
Here's a complete overview of the pump schedules:
As you can see, pump 5 didn't run either, pump 6 did however...
Rob, I know it sounds strange but it more and more looks like the pumps are activated randomly.
This time it is pump 5 that isn't running either, next time I think it will be another one.
Uploaded the test sketch this morning.
I will show you what I did:
- checked Arduino IDE version 1.6.5, used document "First Time Proframming Guide"
- closed Arduino program
- put the files "platform.txt" and "RingBuffer.h" into place again according to the FTPG
- removed the complete "libraries" folder in documents/arduino
- copied the complete "libraries" folder from v3.6 unzipped to documents/arduino
- overwritten the "TimeAlarms" folder with the one you mailed me
- copied the calibration file for my display (CPLD 7 inch) to Arduino/libraries/Utouch and have overwritten the one already there
- uncommented correct display in the DisplayV2_OOP.ino you've send me
- removed all files from both the SD cards
- copied all original files from v3.6 unzipped, controller and display, to SC cards
- uploaded original v3.6 sketch to controller
- uploaded the DisplayV2_OOP.ino to display
I haven't touched the controller sketch and the only thing modified in the display sketch (DisplayV2_OOP.ino) was setting the display right.
I also left the original pump names as they are, just to be sure.
I changed the pump 4 schedule to 10:15 again, checked the others but did not change any further settings.
After that I pressed "resume".
Hopefully turned on the light in the cabinet to see whether dosing happens...
As you can see: NO dosing at 10:15...
Finally I dosed manually (pump 4).
It's a little later now, made some new pics to show you my settings.
These are the settings of pump 4:
Here's a complete overview of the pump schedules:
As you can see, pump 5 didn't run either, pump 6 did however...
Rob, I know it sounds strange but it more and more looks like the pumps are activated randomly.
This time it is pump 5 that isn't running either, next time I think it will be another one.