08-18-2018, 05:59 PM
Hi Rob,
The third display board decided to quit on me about an hour after hooking it up.
I got it in the mail today, hooked it up, and everything looked fine. I reset some of my configurations no problem. I wanted to change the lighting setup but it told me to wait until the mode finished changing. I went back about an hour later, pressed a button, the display locked up like the other times, and wouldn't come back up (reset power).
Whether the SD card is installed or not, the display powers up but does not display anything. No static, no lines, just all black but is lit up. The LED's on the display light up, as do the LED's on the display board and Arduino. I used a new arduino with a fresh sketch installed, and a new display, so I'm pretty sure the issue is on the board. Any advice on where to start looking?
Thanks!
The third display board decided to quit on me about an hour after hooking it up.
I got it in the mail today, hooked it up, and everything looked fine. I reset some of my configurations no problem. I wanted to change the lighting setup but it told me to wait until the mode finished changing. I went back about an hour later, pressed a button, the display locked up like the other times, and wouldn't come back up (reset power).
Whether the SD card is installed or not, the display powers up but does not display anything. No static, no lines, just all black but is lit up. The LED's on the display light up, as do the LED's on the display board and Arduino. I used a new arduino with a fresh sketch installed, and a new display, so I'm pretty sure the issue is on the board. Any advice on where to start looking?
Thanks!