09-17-2020, 12:58 AM
Sorry I'm confused, if you get 3.2v or even 2.8v with 300 ohm resistor it should switch, does it not? That's plenty of voltage to turn on the transistor.
11 mA sounds good so the pin isn't overworking like I thought it could be.
Those solder tracks aren't good, I'll need to be more careful but I don't think the power bar one will cause a problem as it does switch but yeah not good.
11 mA sounds good so the pin isn't overworking like I thought it could be.
Those solder tracks aren't good, I'll need to be more careful but I don't think the power bar one will cause a problem as it does switch but yeah not good.