Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PH Sensor board
#1
Is that a female usb connector on the Robo-Tank Isolated pH Circuit for reef-pi? If so can anyone provide the pinout.  I am trying to figure out what cable I need to hook it to my RPi.

Thanks,
Brett
Reply to top
#2
Hi Brett, the pH board has standard header pins to connect it, it requires +5v, GND, SDA and SCL. I do send along a set of 10" header wires so you can connect it directly to the Pi GPIO header pins. If you have something else you want to connect it to I have some header pins with pins so they can be soldered or whatever.
[-] The following 1 user Likes Rob F's post:
  • brett021
Reply to top
#3
Thanks. I'm designing a board to run reef pi on a quarantine tank.
[-] The following 1 user Likes brett021's post:
  • Rob F
Reply to top
#4
Right on, sounds like fun. :)
Reply to top
#5
(12-29-2022, 11:24 PM)Rob F Wrote: Right on, sounds like fun. :)
Rob,
Do you use the JST-XH series connectors? I wanted to order some of the sensors from you and I wanted to be sure they are plug and play for my QT board I'm building. I plan on buying your Robo tank controller for my main reef tank when I get it set up.

Thanks,
Brett
Reply to top
#6
Hi Brett, happy new year! Yeah the 4 pin are XH with 2.5mm spacing, the 3 pins are PH with 2.0mm spacing.
Reply to top
#7
(01-01-2023, 07:56 PM)Rob F Wrote: Hi Brett, happy new year! Yeah the 4 pin are XH with 2.5mm spacing, the 3 pins are PH with 2.0mm spacing.
Thanks for the info and Happy New year to you also.
[-] The following 1 user Likes brett021's post:
  • Rob F
Reply to top


Possibly Related Threads…
Thread Author Replies Views Last Post
  Standalone power board gandalf 5 3,359 02-04-2022, 07:53 PM
Last Post: Rob F
Photo Coralux LED meanwell driver board setup Jeffer 3 2,975 12-14-2021, 01:09 AM
Last Post: Rob F
  Outlets on power board not working Dukereef 18 8,978 09-17-2020, 01:11 AM
Last Post: Rob F

Forum Jump:

Current time: 03-29-2024, 07:44 AM