I have a new fully assembled Robo-tank that I am setting up my LED lighting with.
I believe I have my Reef-Pi up and running correctly.
I am trying to get my 0-10volt PWM jacks to operate.
I am using a 12 volt 20 amp supply.
I will use channels of 5 to 8 LED's, each on a separate schedule.
Currently I am getting no output through to the drivers.
It must be something simple that I am missing.
Any help on LED's, Reef-Pi or my Robo-tank would be appreciated.
Has anyone used this driver board on a Robo-Tank controller?
I believe I have my Reef-Pi up and running correctly.
I am trying to get my 0-10volt PWM jacks to operate.
I am using a 12 volt 20 amp supply.
I will use channels of 5 to 8 LED's, each on a separate schedule.
Currently I am getting no output through to the drivers.
It must be something simple that I am missing.
Any help on LED's, Reef-Pi or my Robo-tank would be appreciated.
Has anyone used this driver board on a Robo-Tank controller?