08-26-2020, 04:22 PM
Hi - I have finished my DIY build and have plugged in the temp probe.
The screen shows the graph of a period of time and the the probe is testing every 60sec.
The actual temp is hard to find, it is displayed at the top of the graph, but it is not correct, is this an average temp?
The only place I can find that has the real time actual temp is under the calibration screen where it shows the raw data.
OK - the graph is showing the temp but you have to run your mouse over the last reading on the graph to see what it is.
Is it possible to have a screen that shows what the temp actually is?
Why is the reading at the top of the left hand side of the graph not accurate?
(does not seem to update)
Thanks
The screen shows the graph of a period of time and the the probe is testing every 60sec.
The actual temp is hard to find, it is displayed at the top of the graph, but it is not correct, is this an average temp?
The only place I can find that has the real time actual temp is under the calibration screen where it shows the raw data.
OK - the graph is showing the temp but you have to run your mouse over the last reading on the graph to see what it is.
Is it possible to have a screen that shows what the temp actually is?
Why is the reading at the top of the left hand side of the graph not accurate?
(does not seem to update)
Thanks