03-07-2019, 10:53 PM
Hmm, this isn't making sense, can you upload the sketches from the link below to display and controller and copy the results in the serial monitor for each to a blank sketch so you can save them. This way I can load your current settings on my controller and can go through it.
After uploading open the serial monitor and it'll start printing in 10 seconds and will take about 5 minutes for each to complete, when it stops printing to serial monitor its finished.
https://www.robo-tank.ca/forum/attachment.php?aid=386
After uploading open the serial monitor and it'll start printing in 10 seconds and will take about 5 minutes for each to complete, when it stops printing to serial monitor its finished.
https://www.robo-tank.ca/forum/attachment.php?aid=386