Okay, what'd I screw up now?
I was troubleshooting the pH probe periodically reading 0. Unplugged everything, installed a 10k resistor on the probe port, plugged everything else back in. Still had the issue. Added dtparam=i2c_arm_baudrate=10000 to the /boot/config.txt and rebooted. (That seems to have fixed that.) So, I shut down again, removed the resistor and reinstalled the probe. Powered up.
pH is reading just fine. BUT, I have two errors. One on the dashboard and one in the error log:
{"error":"stats for id: '3' not found"} | HTTP 404 appears on the dashboard
And this in the error log:
May 18 11:24:21 failed to initialize driver: Extra Ports Error: remote I/O error
And the dosing pumps are back to not working... ARGH. :P
I was troubleshooting the pH probe periodically reading 0. Unplugged everything, installed a 10k resistor on the probe port, plugged everything else back in. Still had the issue. Added dtparam=i2c_arm_baudrate=10000 to the /boot/config.txt and rebooted. (That seems to have fixed that.) So, I shut down again, removed the resistor and reinstalled the probe. Powered up.
pH is reading just fine. BUT, I have two errors. One on the dashboard and one in the error log:
{"error":"stats for id: '3' not found"} | HTTP 404 appears on the dashboard
And this in the error log:
May 18 11:24:21 failed to initialize driver: Extra Ports Error: remote I/O error
And the dosing pumps are back to not working... ARGH. :P