06-15-2016, 06:40 PM
(06-15-2016, 06:23 PM)Rob F Wrote: Hi Fred, you want to use the first bit of code as you did. Try closing the Arduino IDE, in the download package go to the calibration folder and copy the uTouchCD.h file in the the ElecFreaks display folder. Paste that file in the your documents/arduino/libraires/uTouch/ folder and overwrite the existing file. Then open the sketch again and upload it. If that doesn't work and your other controller uses the same screen plug this screen into that controller to see if it works. If both displays are the same you won't need to change anything on the working controller. If it doesn't work on it then it sounds like the display is bad.
All good now. The issue was, i didn't close and reopen Arduino when overwriting the libraries
