Hi,
I already wrote a post about the PWM outputs : https://www.robo-tank.ca/forum/Thread-No...ht-outputs
I found another strange thing and I'm curious if I'm the only one expierencing this.
When you go to light settings, there are 4 modes.
Take a close look at the Channel 1 Slider...
Go to any mode but "Moon" and set the Channel 1 slider in any position.
Output 1 sends out pwm pulses according to the slider setting.
Now go to "Moon" and set Channel 1 slider in any position.
Output 1 sends out pwm pulses according to the slider setting in "Moon" mode.
Now switch to the other previous set mode and look at slider Channel 1.
It represents the setting you made before.
Now switch to "Moon"...
Please have a look at Channel 1 slider.
In my case it 's position is 0, eventhough I have set it to another position.
The output keeps on producing the pwm pulses that fits the previous "Moon" setting of Channel 1, but the slider drops to the bottom... in my case I mean... ;-)
So normaly you will not notice, light works as it should.
Am I the only one having this issue?
I'm running V2.3 original.
Kind regards,
Arne.
I already wrote a post about the PWM outputs : https://www.robo-tank.ca/forum/Thread-No...ht-outputs
I found another strange thing and I'm curious if I'm the only one expierencing this.
When you go to light settings, there are 4 modes.
Take a close look at the Channel 1 Slider...
Go to any mode but "Moon" and set the Channel 1 slider in any position.
Output 1 sends out pwm pulses according to the slider setting.
Now go to "Moon" and set Channel 1 slider in any position.
Output 1 sends out pwm pulses according to the slider setting in "Moon" mode.
Now switch to the other previous set mode and look at slider Channel 1.
It represents the setting you made before.
Now switch to "Moon"...
Please have a look at Channel 1 slider.
In my case it 's position is 0, eventhough I have set it to another position.
The output keeps on producing the pwm pulses that fits the previous "Moon" setting of Channel 1, but the slider drops to the bottom... in my case I mean... ;-)
So normaly you will not notice, light works as it should.
Am I the only one having this issue?
I'm running V2.3 original.
Kind regards,
Arne.