02-27-2016, 09:39 AM
(This post was last modified: 02-27-2016, 10:48 AM by dagsterbox.)
Dear all,
Could you please tell me the step by step procedure to connect display board and the controller. The display is powered by the controller but there is no connection between both boards.
Thx.
I made some Due tests with the test file, and I got this message
Initializing sd card...
SUCCESS - sd card initialized.
Wait 5 seconds for test to begin
Serial1 Sent Signal to Power Bar
I did the same with the test files for the Mega but nothing is displaying.
What are the next steps ?
Could you please tell me the step by step procedure to connect display board and the controller. The display is powered by the controller but there is no connection between both boards.
Thx.
I made some Due tests with the test file, and I got this message
Initializing sd card...
SUCCESS - sd card initialized.
Wait 5 seconds for test to begin
Serial1 Sent Signal to Power Bar
I did the same with the test files for the Mega but nothing is displaying.
What are the next steps ?