03-05-2022, 02:27 PM
I have a Robo-Tank Deluxe v2 that I am trying to set up with the DS18B20 temperature probe.
When I go to add the probe in reef-pi, there are no options in the Sensor drop down menu.
I have followed all the installation and configuration instructions and used the install script. I have confirmed that /boot/config.txt contained the following lines:
dtoverlay=w1-gpio,gpiopin=4
dtoverlay=w1-gpio,gpiopin=22
In the second line I have tried pins 22 and 23 with no luck. I have also done a full re-install of Robo-Tank with no luck. As far as I can tell, the proper Connectors have been added.
I have setup and calibrated a pH probe that is functioning as expected.
What am I missing here?
When I go to add the probe in reef-pi, there are no options in the Sensor drop down menu.
I have followed all the installation and configuration instructions and used the install script. I have confirmed that /boot/config.txt contained the following lines:
dtoverlay=w1-gpio,gpiopin=4
dtoverlay=w1-gpio,gpiopin=22
In the second line I have tried pins 22 and 23 with no luck. I have also done a full re-install of Robo-Tank with no luck. As far as I can tell, the proper Connectors have been added.
I have setup and calibrated a pH probe that is functioning as expected.
What am I missing here?