Posts: 25
Threads: 5
Likes Received:
0 in 0 posts
Likes Received:
0 in 0 posts
Reputation:
0
Joined: Jan 2016
Country:
Hi Rob,
Can I use the atlas-scientific pH Circuit with the reef-pi deluxe aquarium controller?
All the best.
Posts: 3,250
Threads: 90
Likes Received:
163 in 120 posts
Likes Received:
163 in 120 posts
Reputation:
184
Joined: Sep 2015
Country:
Hi Iliyan, yeah the Atlas circuit will work. It won't solder to the controller board but can sit in the same location and connect using short jumpers.
Posts: 436
Threads: 23
Likes Received:
8 in 8 posts
Likes Received:
8 in 8 posts
Reputation:
8
Joined: Sep 2015
Country:
I guess using the tentacle board is out
Posts: 3,250
Threads: 90
Likes Received:
163 in 120 posts
Likes Received:
163 in 120 posts
Reputation:
184
Joined: Sep 2015
Country:
The tentacle board will be ok. Just run jumpers from it to the controller just like an Arduino or whatever. However at this time only the pH circuit will be read, you can leave other circuits in the shield but they won't blink at this time.
Posts: 436
Threads: 23
Likes Received:
8 in 8 posts
Likes Received:
8 in 8 posts
Reputation:
8
Joined: Sep 2015
Country:
can I use more than one temp probe?
Posts: 3,250
Threads: 90
Likes Received:
163 in 120 posts
Likes Received:
163 in 120 posts
Reputation:
184
Joined: Sep 2015
Country:
Yeah you can attached many, Reef-pi's been tested with up to 7 and more should be ok. There's all on one pin so cable length is more a limiting factor but should be plenty. No DHT22 only DS18B20.