02-13-2016, 11:03 PM
(02-13-2016, 10:22 PM)rott Wrote: nope no go I have the wire going from the 12v power supply mounted to the top of the box and the other end going to ground on the edge of the board under where the power comes in and also tried it ground pin in the Ethernet card
ok so I cut the end off a wall plug I had and wired it to the 12v dc PSU for the controller and have the new board plugged with that so every thing is running from the same PSU and still no ip addy
maybe cause I have my router password protected ?? or I have UPnP turned off did you have to open a port or anything for it Rob when you set yours up
I don't think its because the router is password protected, mine is as well. I'm not sure about the other settings but it could be something there. Is the plug on your display staying green when the hub is connected? Keep everything connected and have the hub connected to the computer and open the serial window in the Arduino IDE, post all the messages it prints out, it could take a minute or two to respond. When you select the text in the serial window press "Ctrl + C" to copy it as the mouse doesn't work.
