06-16-2019, 02:19 PM
Hi Notorious.jatt, thanks, the ports haven't changed just the name of the port. The same ports you used for ATO you still use but change the name of them so it matches gen3.
You can get the correct port names from the new faceplate. Here's a link. For everything start with the first port on your controller and it'll be the same as the first port for same type on faceplate. For example water temp is the first temp port on Gen 2, that would be "temp 1 / port 9" in the software.
https://www.robo-tank.ca/forum/Thread-Co...-Faceplate
You do have to enable the network, go to settings, system and bottom of screen you will see option. Once you change it and go back it'll appear unchecked but it's still ok. That is fixed for next update coming soon.
You can get the correct port names from the new faceplate. Here's a link. For everything start with the first port on your controller and it'll be the same as the first port for same type on faceplate. For example water temp is the first temp port on Gen 2, that would be "temp 1 / port 9" in the software.
https://www.robo-tank.ca/forum/Thread-Co...-Faceplate
You do have to enable the network, go to settings, system and bottom of screen you will see option. Once you change it and go back it'll appear unchecked but it's still ok. That is fixed for next update coming soon.