04-17-2018, 06:33 PM
Hi jmcadsl, the green plug indicates if the controller and display are communicating, if it turns red they are not. When this happens does the display still respond and can you still navigate? It could be related to the ethernet patch cable you're using to connect it, do you have another to try?
Also because you only got the boards I'm not sure if I told you about the resistor that should be added to the Arduino Due. This usually only effects startup but should still be done, here's a link showing where it goes.
https://www.robo-tank.ca/forum/Thread-Pr...is-stopped
When this happens again unplug the ethernet cable from the display and plug back in, if the red dots on start up screen start moving immediately that means the controller is running ok, if it hangs then the controller is locked up.
Also because you only got the boards I'm not sure if I told you about the resistor that should be added to the Arduino Due. This usually only effects startup but should still be done, here's a link showing where it goes.
https://www.robo-tank.ca/forum/Thread-Pr...is-stopped
When this happens again unplug the ethernet cable from the display and plug back in, if the red dots on start up screen start moving immediately that means the controller is running ok, if it hangs then the controller is locked up.
