09-18-2021, 06:23 AM
(This post was last modified: 09-18-2021, 07:08 AM by fietsenrex.)
So, got around to posting pictures :p
As you can see I started with wiring and fitting the receptacle
Next I soldered everything in place (+ and - are underneath the purple wire
And when it was all closed up it almost looked like a stock feeder
It was pretty easy to do, you just have to pop off the screen, remove the container and unscrew 1 screw in the battery compartment.
I also had to remove the motor and gearbox due to the position of the receptacle but if you place it elsewhere it’s not needed
Also made a short clip showing that it works as intended
https://youtube.com/shorts/_CwDyooZNsY?feature=share
As you can see I started with wiring and fitting the receptacle
Next I soldered everything in place (+ and - are underneath the purple wire
And when it was all closed up it almost looked like a stock feeder
It was pretty easy to do, you just have to pop off the screen, remove the container and unscrew 1 screw in the battery compartment.
I also had to remove the motor and gearbox due to the position of the receptacle but if you place it elsewhere it’s not needed
Also made a short clip showing that it works as intended
https://youtube.com/shorts/_CwDyooZNsY?feature=share