02-25-2017, 01:35 PM
I agree that the robo-tank is freaking neat and I love all the features and value.
I suppose my biggest concern is that I might fry the AquaGro lights via constantly elevated heat levels if the TMC controller and drivers really are that much more efficient than "traditional" controllers? Another concern is that I might end up making the AquaGro leds less efficient in terms of watts per PUR again this is only if the TMC drivers are actually that much better?
https://www.1000bulbs.com/pdf/understand...rivers.pdf
https://www.designnews.com/electronics-t...6129147250
^ If only that was more specific to what components to use! I'm 90% convinced I could copy a schematic to a breadboard and 70% sure I could learn the skills to transfer it to an actual circuit board (sounded like a lot of steps/pain last time I read up on it).
I suppose my biggest concern is that I might fry the AquaGro lights via constantly elevated heat levels if the TMC controller and drivers really are that much more efficient than "traditional" controllers? Another concern is that I might end up making the AquaGro leds less efficient in terms of watts per PUR again this is only if the TMC drivers are actually that much better?
https://www.1000bulbs.com/pdf/understand...rivers.pdf
https://www.designnews.com/electronics-t...6129147250
^ If only that was more specific to what components to use! I'm 90% convinced I could copy a schematic to a breadboard and 70% sure I could learn the skills to transfer it to an actual circuit board (sounded like a lot of steps/pain last time I read up on it).