Robo-Tank v6.0 is Ready - Now v6.5

[Rob F]

Hi, today you have to setup 2 custom rules for the ATO, once I get the ATO functions built in it'll be easier.

If you only use one sensor for ATO create the custom rule for it and have it turn the pump on when water isn't touching the sensor. Then create a 2nd custom rule using the same sensor and have it turn the pump off when water is touching the sensor.

Then for the reservoir create another custom rule using the sensor to monitor the reservoir level and have it turn off the pump when water isn't touching the sensor. Then like the ATO create another custom rule to have the pump back on when water is detected.

Overall you should have 4 custom rules. I would start with just the 2 for ATO to get that working as expected and then work on the reservoir sensor.

If you use 2 sensors for ATO you can combine like you did above.

Hope this makes sense, if you need more info let me know.