Robo-Tank v6.0 is Ready - Now v6.5

[Craig]

Cool, Actually had problem activating dc ato pump, so went back to version 1 controller(swapped sd card with Robo Tank into version 1) still no joy so went back to reef pi and still no joy, my multimeter is at work and have covid in the house so can't go and pick it up. But assuming pump is kaput.

One other issue I do have though is that 2 of my ac outlets won't activate, I have the 1 outlet version, works fine on reef pi but not on robo tank any ideas? tried both ac bar ports on the controller but no joy

Other than that I have it on my tank and looks great, won't need another outlet for a while until it gets colder and need another heater as back up and also when I get round to getting my doser back up and running. but still working out dosages with the tank anyway

Thanks again mate

---

Oh and one other thing anyway to change temperature probe names? Too a bit of mucking round and had to change what probes do due to length of probe. Oh and 1 probe I can't set a rule for as it comes up as a float switch instead of a temp probe. Reads ok but can't get it to be used to control heaters

For the DC port, were you able to try it on a different DC port?

When you change controllers are you changing board type in the app on the settings page? As the power bar works with reef-pi it sounds like a GPIO configuration issue. 

At the moment to change the temp name you have to go into the database, the 2nd post on this thread explains how to log in. Once you get in you need to go to "ds18b20" table and you'll see all the sensors and can edit the name.

Sorry about the custom rules, currently there's an issue where you can't use pH probes and I suspect this will be related as it's probably an ID issue. I'll definitely get the rules sorted out for next update, I'll try and have it ready in about a week.

Yep changed board type to match version, possibly, I think its the same plugs that don't work if I use either of the power board outputs on the controller. No stress though probably need another power board at some stage anyway

Yeah tried all DC ports, no go and swapping back to reef pi with old controller couldn't get the pump to work either, suspect pump is buggered, and cheap to get a replacement will let you know in a couple f days(will also have my multimeter by then as well so can confirm)
Yeah I remembered about database after I sent the last email and thought that would be how to do it.