04-25-2022, 07:37 PM
Hey Craig, great, thanks for testing it out. I think the issues you had last time was caused by me, a few packages didn't install so well but it looks like it might be finally sorted out. If you come across any issues let me know.
The output on the fan plug is the same as the controller input, probably 12v. The port is controlled via a pin on the pca9685 so you need to setup a connector in reef-pi using PCA9685 driver and pin 5 assuming you have v3 controller. You can add it as a jack or connector as you'll likely need to run at 100% 24/7. If you want it to turn on when the controller is powered you can use the + positive pin on the fan plug and run the ground to a common ground point, maybe on a temp port, you can solder it internally.
Not sure, but looks like your remaining message was cut off.
The output on the fan plug is the same as the controller input, probably 12v. The port is controlled via a pin on the pca9685 so you need to setup a connector in reef-pi using PCA9685 driver and pin 5 assuming you have v3 controller. You can add it as a jack or connector as you'll likely need to run at 100% 24/7. If you want it to turn on when the controller is powered you can use the + positive pin on the fan plug and run the ground to a common ground point, maybe on a temp port, you can solder it internally.
Not sure, but looks like your remaining message was cut off.
