Some new qustions (i've was able to upgrade to 6.3)
1. i think the dosing pump are running too fast, they are Kamoer KFS, it should do 18ml/minutes but here is running MUCH faster, any way to slower it down?
2. when doing the schedule , how can I set how much ml to dose ? in example, 0.5ml at 18:40:40 daily ?
3. i've seen that I can set the hour at which dosing pump is powered on and at which the dosing pump is powered off (creating 2 schedules) but even setting both at 1 seconds in difference, the pump is running for 4-5 seconds anyway (and it starts before the schedule time)
4. is the ph sensor temperature corrected automatically ? If yes, should I configure something in robo-tank to specifcy which temp probe to use for temp correction ? (in case I have multiple probes)
1. i think the dosing pump are running too fast, they are Kamoer KFS, it should do 18ml/minutes but here is running MUCH faster, any way to slower it down?
2. when doing the schedule , how can I set how much ml to dose ? in example, 0.5ml at 18:40:40 daily ?
3. i've seen that I can set the hour at which dosing pump is powered on and at which the dosing pump is powered off (creating 2 schedules) but even setting both at 1 seconds in difference, the pump is running for 4-5 seconds anyway (and it starts before the schedule time)
4. is the ph sensor temperature corrected automatically ? If yes, should I configure something in robo-tank to specifcy which temp probe to use for temp correction ? (in case I have multiple probes)