(02-04-2022, 08:26 PM)Rob F Wrote: Sorry the app isn't setup properly for v2, all the pinouts are different. I almost have an update ready that changes things easy.
With that said if you go to the "configure ports" screen and use the "advanced" tab you can select sensors or outputs from the "function" drop down and ignore the "Robo-Tank" label which is mainly only on that screen anyways.
For example, if you scroll to bottom of page you'll see the 16 pins for PCA9685, pin 15 will be DC1 but on v2 DC1 is pin 0. So you need to edit pin 0 and change function to dosing pump, then it should work. You need to do this to all the ports you want to use. If you go through the manual at the end of each sensor type section is a table showing the pin number for each port. Here's the DC ports.
I did. It doesn't work, the pump doesn't move.
Dosing pumps now works, pin are 1, 2, 3 and 4, not 0
With 6.0 also works the ph probe and an extender is detected (even if not attached).
6.3 doesn't detect anything.
Upgrading and downgrading is impossible, the only way is to delete everything (/var/www/html, drop database, drop services) and re-install from scratch
