Robo-Tank v6.0 is Ready - Now v6.5

[pwest]

I've attached a screenshot of my lighting program, and a second screenshot of the light program status block.  If expanded, the first two modes have the slider at 100%, and the last has it at zero %, my idea being that the lights ramp up from 2:00 to 3:00, stay on high until 11:00, and then ramp down to zero at midnight. 

When I came home today around 18:00, the lights were not on, and the status indicator was as shown.  If I'm reading that properly, it is, in effect saying that it is currently in the ramp down mode (when it should be in Full Intensity), and, even stranger, that the Ramp Down mode (that it thinks it is already in) will (correctly) start in 4+ hours.

When I clicked open the 'Full Intensity' mode, the lights immediately came on!

Any thoughts about what's going on?  Is my lighting program not correct?  (Note that I put in the 1-minute offsets between modes because I had observed this same confusion yesterday when I had the switchover on/off times to be the same.