10-16-2021, 04:11 PM
I applied your update, but I think I need a bit of a tutorial here. This is how I had my lighting setup on my previous controllers
One wire, in this case GPIO 0, controlling the lights on a diurnal program using PWM. Becasue at 0% PWM the lights don't always go completely off, the AC for these lights is also plugged into an AC switch controlled by DC Port 1, GPIO 15.
So, my lighting program would specify a diurnal program via PWM starting at 14:00 and ending at 23:59, and the AC power would be enabled during the same interval.
I'm having trouble understanding how this should be set up.
With my initial attempt, the lights are not on, a notification on the home screen sez: "Lights starting in 20:00 hrs". My thinking is that they should be ON now, off in 6 hrs, and back on in 20 hrs...
Any guidance would be appreciated.
-Phil
One wire, in this case GPIO 0, controlling the lights on a diurnal program using PWM. Becasue at 0% PWM the lights don't always go completely off, the AC for these lights is also plugged into an AC switch controlled by DC Port 1, GPIO 15.
So, my lighting program would specify a diurnal program via PWM starting at 14:00 and ending at 23:59, and the AC power would be enabled during the same interval.
I'm having trouble understanding how this should be set up.
With my initial attempt, the lights are not on, a notification on the home screen sez: "Lights starting in 20:00 hrs". My thinking is that they should be ON now, off in 6 hrs, and back on in 20 hrs...
Any guidance would be appreciated.
-Phil