Robo-Tank v6.0 is Ready - Now v6.5

[Rob F]

That makes me feel better that it wasn't just in my head! Thank you for being on top of it and tanking care of it. One thing I've noticed so far today is that if I go tot edit a PIN (via advanced tab) the I hit save it doesn't do anything.

Thanks for letting me know, when I added all the features I checked the edit save but then on the normal view I added an check to make sure user can't save pin details if there's no name and that broke the advance tab, it's fixed. 

Hello

I installed your new program on rasberry pi zerow. It looks great.
But I have a problem with the heater. The heater switches on at the set temperature (24.8 C) but when it reaches the temperature (25.2 C)
do not turn off.
Do you have any idea why this is happening.

Greetings
Bostjan

Hi Bostjan, unfortunately I messed up with the custom rules when turning off something that's why it's not working. I'm going to post an update later tonight so you'll see a link by clock when it's ready or you can go to system settings and check for an update.

You will need to delete the custom rules and add back.

Hi, thanks for trying it out, was your card freshly formatted before you started? Apache seems to have trouble if operating system isn't update to date however the install script should have done that first. It also seems if reef-pi is installed it'll have issues, probably other things too so I'm starting to think a fresh formatted card is best.

During the initial setup wizard did it prompt about an I2C device? That's all there is to setting it up, it then asks for a name and it's finished. Any change when it prompted you click on the pca9685 instead?

If you can log into the database based on the 2nd post in this thread and go to the "i2cDevices" table do you see some?

Now that it's running you should be able to run the install script again, it'll roll through the install and should reset the database so you can go through the initial setup wizard, at this time in the UI you can't access I2C devices.

---

I am still having issues with my ph probe.  it shows in the database but not any where else.  I tried reinstalling the software twice.

As it's in the i2cDevices table do you also see it in the "probes" table? If it is in the probes table verify the "plugged" field is set to 1. If it's 0 it won't show.

If it's not in the "probes" table go back to the i2cDevices table and verify "enabled" = 1, "running" = 1 and then set "new" to 1. As soon as you do that the popup will appear in the user interface asking what the i2c device is.