(10-14-2021, 10:37 AM)Rob F Wrote: Hi, thanks for trying it out, was your card freshly formatted before you started? Apache seems to have trouble if operating system isn't update to date however the install script should have done that first. It also seems if reef-pi is installed it'll have issues, probably other things too so I'm starting to think a fresh formatted card is best.
During the initial setup wizard did it prompt about an I2C device? That's all there is to setting it up, it then asks for a name and it's finished. Any change when it prompted you click on the pca9685 instead?
If you can log into the database based on the 2nd post in this thread and go to the "i2cDevices" table do you see some?
Now that it's running you should be able to run the install script again, it'll roll through the install and should reset the database so you can go through the initial setup wizard, at this time in the UI you can't access I2C devices.
I am still having issues with my ph probe. it shows in the database but not any where else. I tried reinstalling the software twice. ph probe working now
