Robo-Tank v6.0 is Ready - Now v6.5

[Rob F]

Hi Rob! Thanks for getting back to me, sorry it took a second for me to respond...I had to entertain some Halloween festivities lol.
I think I at least figured out getting the DC ports working (that was relatively straight forward. I went into the PHPadmin and switch the pins I needed for sensors to "type 8" since I am running float switches and 4 normally opened micro switches. For the life of me I can't get the sensors to actually work. My support ID is: 899499554 if that helps. It could also be wiring on my end...I haven't ruled that out.

For the microswitches I have them wired one on COM the other on NO. COM goes to 5V, NO goes to Data. and I have them set in Other and P-U. I'm not an expert by any means.

Something that might be cool in a future update is the ability to see the status of switches. It'd help me immensely instead of creating a rule, restarting the controller, and then testing to see if it actuates. 

Outside of all that the rest of the new software rocks!!! I really really like it.

I set the update for your ID albinochicken89 so it should show one is available within an hour of this post. Had to make a bunch of changes to the update system so took longer than expected. The sensors should show on dashboard and those changes on Configure Ports screen. After you update it'll still tell you v6.1 is available. That's because these one person updates don't actually update the version number. You'll have to let me know after you run it so I can remove you ID. 

This shows the 5 sensor types available on dashboard, the icons update based on status. I did add a toggle switch as a sensor type. The images has two float switches to show how the icon changes.