10-11-2021, 03:24 PM
Hi Rob! Thanks for getting back to me, sorry it took a second for me to respond...I had to entertain some Halloween festivities lol.
I think I at least figured out getting the DC ports working (that was relatively straight forward. I went into the PHPadmin and switch the pins I needed for sensors to "type 8" since I am running float switches and 4 normally opened micro switches. For the life of me I can't get the sensors to actually work. My support ID is: 899499554 if that helps. It could also be wiring on my end...I haven't ruled that out.
For the microswitches I have them wired one on COM the other on NO. COM goes to 5V, NO goes to Data. and I have them set in Other and P-U. I'm not an expert by any means.
Something that might be cool in a future update is the ability to see the status of switches. It'd help me immensely instead of creating a rule, restarting the controller, and then testing to see if it actuates.
Outside of all that the rest of the new software rocks!!! I really really like it.
I think I at least figured out getting the DC ports working (that was relatively straight forward. I went into the PHPadmin and switch the pins I needed for sensors to "type 8" since I am running float switches and 4 normally opened micro switches. For the life of me I can't get the sensors to actually work. My support ID is: 899499554 if that helps. It could also be wiring on my end...I haven't ruled that out.
For the microswitches I have them wired one on COM the other on NO. COM goes to 5V, NO goes to Data. and I have them set in Other and P-U. I'm not an expert by any means.
Something that might be cool in a future update is the ability to see the status of switches. It'd help me immensely instead of creating a rule, restarting the controller, and then testing to see if it actuates.
Outside of all that the rest of the new software rocks!!! I really really like it.