10-15-2020, 08:08 PM
I didn't add a mosfet, just opened it up and soldered directly to the leads using post that someone had written here.
My knowns/findings:
*Plugged into DC8/Feeder
*Equipment added and mapped to DC8/Feeder
*3.3v from + to ground
*3.6mv from data to ground
*Turning the equipment switch On/Off did not change the data voltage.
I suspect the data pin should be sending 3.3v when turned on?
My knowns/findings:
*Plugged into DC8/Feeder
*Equipment added and mapped to DC8/Feeder
*3.3v from + to ground
*3.6mv from data to ground
*Turning the equipment switch On/Off did not change the data voltage.
I suspect the data pin should be sending 3.3v when turned on?