09-03-2020, 12:38 PM
Sockets 3&4 are not working as they should.
I am reasonably sure they did when I first tested them but not now, actually very sure as I tested each with a light.
I have no temp or timer programs running all deleted as I run tests. Nothing should be turning these on or off.
But I did try and save a inlet using pin 2 (mistake) but can not see if it did anything, your last reply solved that issue with the other inlets, all loaded but output channels 3 & 4 will not work....
Under equipment I can turn on and off ALL but 3 & 4.
3 & 4 do nothing.. no click.
If i power down the box, (pull the power cord) 3 goes out, I can turn it on but can not turn it off.
4 stays off.... will not turn on.
under timer i can make all BUT 3 and 4 cycle every 10sec.
Any ideas before I format and reload the SSD card?
thanks as usual for the great support.
I am reasonably sure they did when I first tested them but not now, actually very sure as I tested each with a light.
I have no temp or timer programs running all deleted as I run tests. Nothing should be turning these on or off.
But I did try and save a inlet using pin 2 (mistake) but can not see if it did anything, your last reply solved that issue with the other inlets, all loaded but output channels 3 & 4 will not work....
Under equipment I can turn on and off ALL but 3 & 4.
3 & 4 do nothing.. no click.
If i power down the box, (pull the power cord) 3 goes out, I can turn it on but can not turn it off.
4 stays off.... will not turn on.
under timer i can make all BUT 3 and 4 cycle every 10sec.
Any ideas before I format and reload the SSD card?
thanks as usual for the great support.