01-31-2021, 08:52 AM
I need help with my issue:
1: I need to drain the water until the swimmer reaches a low level then the pump switches off
2: Disconnect the sockets x x x
3: wait a few seconds
4: filling the tank with water as described above
5: socket x x x switched on
My problem is that after draining, immediately fill with water or after reaching a high level, the pump for draining is still running.
1: I need to drain the water until the swimmer reaches a low level then the pump switches off
2: Disconnect the sockets x x x
3: wait a few seconds
4: filling the tank with water as described above
5: socket x x x switched on
My problem is that after draining, immediately fill with water or after reaching a high level, the pump for draining is still running.