02-13-2016, 09:36 PM
So I assume both of you are only having problems with the expansion hub? Everything is ok until you connect it? I had the exact same problem in the original post on this thread before I realized what it was.
On the expansion hub use the ground hole in the middle of the board on the left side, its along the edge. A lot of the grounds on the USB jacks are switched so some aren't connected. If you're using a seperate power supply for the expansion hub connect a ground wire from the controller power supply to the expansion hub power supply to test it.
On the expansion hub use the ground hole in the middle of the board on the left side, its along the edge. A lot of the grounds on the USB jacks are switched so some aren't connected. If you're using a seperate power supply for the expansion hub connect a ground wire from the controller power supply to the expansion hub power supply to test it.