07-09-2019, 03:00 PM
Hi Dave, I found this sensor that should work ok. There's also some cheap analog sensor boards that might work but probably be replaced if they actually get wet.
https://www.robo-tank.ca/en/Accessories/...45c67.html
https://www.amazon.com/Floor-Water-Senso...7234&psc=1
I haven't been able to get one of the jecod pumps but I'm pretty sure it can be controlled but it might need a couple components. If you took pictures and some voltages maybe we could figure it out. I would say the same thing applies for the gyre pumps but you'll have to open the controller so we can see what makes it tick. With all that said there isn't really a system to control them so I would need to add code to control them which I'm ok to do.
You can connect multiple power bars, how far away will it be? I'm estimating as is you could use about 14 meters between the 2 power bars.
https://www.robo-tank.ca/en/Accessories/...45c67.html
https://www.amazon.com/Floor-Water-Senso...7234&psc=1
I haven't been able to get one of the jecod pumps but I'm pretty sure it can be controlled but it might need a couple components. If you took pictures and some voltages maybe we could figure it out. I would say the same thing applies for the gyre pumps but you'll have to open the controller so we can see what makes it tick. With all that said there isn't really a system to control them so I would need to add code to control them which I'm ok to do.
You can connect multiple power bars, how far away will it be? I'm estimating as is you could use about 14 meters between the 2 power bars.