06-19-2019, 04:06 PM
No need to be sorry, I'm sorry you're having issues. Few questions.
What controller board version do you have? On it under the logo it'll say Rev E or something.
Do you have a pH or anything other I2C devices connected?
Is it freezing at the same time or random?
I don't think a fresh install will do much, as it uploaded you had everything correct. It might be worth going to settings, system and doing the restore defaults, this is the same as pre-update sketch but better because there is probably a few eeprom locations not getting setup with pre-update as I've been adding more with updates.
With that said I will email you an update controller sketch to upload, after doing that do the restore defaults and see how it goes.
What controller board version do you have? On it under the logo it'll say Rev E or something.
Do you have a pH or anything other I2C devices connected?
Is it freezing at the same time or random?
I don't think a fresh install will do much, as it uploaded you had everything correct. It might be worth going to settings, system and doing the restore defaults, this is the same as pre-update sketch but better because there is probably a few eeprom locations not getting setup with pre-update as I've been adding more with updates.
With that said I will email you an update controller sketch to upload, after doing that do the restore defaults and see how it goes.