06-17-2019, 03:36 AM
(This post was last modified: 06-17-2019, 04:12 AM by notorious.jatt.)
(06-16-2019, 02:19 PM)Rob F Wrote: Hi Notorious.jatt, thanks, the ports haven't changed just the name of the port. The same ports you used for ATO you still use but change the name of them so it matches gen3.
You can get the correct port names from the new faceplate. Here's a link. For everything start with the first port on your controller and it'll be the same as the first port for same type on faceplate. For example water temp is the first temp port on Gen 2, that would be "temp 1 / port 9" in the software.
https://www.robo-tank.ca/forum/Thread-Co...-Faceplate
You do have to enable the network, go to settings, system and bottom of screen you will see option. Once you change it and go back it'll appear unchecked but it's still ok. That is fixed for next update coming soon.
cool, network is all sorted and works fine, still struggling with ATO system, see the screen shot of the controller, does it look normal? there is no port 7 or port 8 mentioned.
my old board with v4.3, ato main float is on port 3 and ATO backup on port 2 and DC motor on port 4,
i cannt seems to figure out unless i open the controller and start from basic
also the display never goes to sleep or show screensaver, any ideas?