10-12-2018, 10:51 AM
Hi jmcadsl, sorry to hear about the trouble, just to be sure, you are aware the output pin is a GND and not +12v? The GND wire from your pump would go to pump 8 pin on controler and the positive wire from pump would go to the +12v pin.
If you have it correct the transistor could be damaged, for pump 8 the transistor is on the accessory board, there's 4 small transistors in a row behind the sensor ports, T9 is for pump 8.
If you have it correct the transistor could be damaged, for pump 8 the transistor is on the accessory board, there's 4 small transistors in a row behind the sensor ports, T9 is for pump 8.