08-31-2018, 01:25 PM
Hi Rob
Robo-Tank finally arrived today after being held up by customs...….
I have got it set up on test and have the first relay pack connected to it, they all work fine (I had to put the connector on the outside of the controller box to get the VGA cable to connect) going to do the second one tomorrow and make the housings for them.
First impression are very good, cant wait to get it set up on the tank.
Few questions
1 Is there any way to calibrate the touch screen as it is way out at the moment.
2 What connections do I use for the temp sensors, air & humidity, water etc as the only diagram I can find is for the older (I assume) controller.
3 How do I connect an optical (3 wire) level sensor for the ATO, I will use a mech float for the high level (unless I can use optical for that to)
4 What are the usb connections for on the controller (labelled addons/powerbar) and how are they connected.
Sorry if I am being a bit thick but I don't want to just plug things in and blow something up!!!
Robo-Tank finally arrived today after being held up by customs...….
I have got it set up on test and have the first relay pack connected to it, they all work fine (I had to put the connector on the outside of the controller box to get the VGA cable to connect) going to do the second one tomorrow and make the housings for them.
First impression are very good, cant wait to get it set up on the tank.
Few questions
1 Is there any way to calibrate the touch screen as it is way out at the moment.
2 What connections do I use for the temp sensors, air & humidity, water etc as the only diagram I can find is for the older (I assume) controller.
3 How do I connect an optical (3 wire) level sensor for the ATO, I will use a mech float for the high level (unless I can use optical for that to)
4 What are the usb connections for on the controller (labelled addons/powerbar) and how are they connected.
Sorry if I am being a bit thick but I don't want to just plug things in and blow something up!!!
