04-18-2018, 08:26 AM
Just want to check from any clients that have purchased the Robotank unit specifically with reference to the temp/ph/orp/do probe inputs. The reason for my question is that I purchased a Denkovi relay controller and very much the relay control, digital inputs for say door contacts is all ok. What im struggling with and don't want the same problem if I buy the Robotank product is the stability of the readings once you connect the probe and the Atlas Scientific Board.
How stable and how accurate are the readings. The Denkovi board has an 0-10v analog input and reads 0- 1040 for settings but it seems extremely difficult for them to tell me the high and low settings to get say 24 degrees C.
iS that process automated in ROBOTANK other than a small calibration up and down. In otherwards no programming required.
Thanks
Sean
How stable and how accurate are the readings. The Denkovi board has an 0-10v analog input and reads 0- 1040 for settings but it seems extremely difficult for them to tell me the high and low settings to get say 24 degrees C.
iS that process automated in ROBOTANK other than a small calibration up and down. In otherwards no programming required.
Thanks
Sean
