03-09-2022, 02:44 PM
Based on v2 PDF manual, the feeder ports is available via PCA9685 like any other DC/Dosing ports, so it should be PWM too , isn't it ?
Anyway, If I connect just gnd and vcc, the servo tries to power up and move but as soon as I plug the data wire, it stop to work.
I think I have to use the data signal to, but how ?
Anyway, If I connect just gnd and vcc, the servo tries to power up and move but as soon as I plug the data wire, it stop to work.
I think I have to use the data signal to, but how ?