12-19-2016, 04:10 AM
Here's another way to solve the problem, this is Arne's board, he removed the 4 IC's, removed some resistors and replaced some with solder to jump the pads. This is the better way to go if you can remove the IC's.
![[Image: LED_Channel_Mod2.JPG]](https://www.robo-tank.ca/pictures/LED_Channel_Mod2.JPG)
Robo-Tank DIY Aquarium Controller Forum
›
Robo-Tank Arduino Based - NO LONGER AVAILABLE
›
Current News and Design Ideas
Gen 2 Hardware Mod Required
Gen 2 Hardware Mod Required
|
Gen 2 Hardware Mod Required
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Gen 2 Hardware Mod Required - by Rob F - 12-18-2016, 09:48 PM
RE: Gen 2 Hardware Mod Required - by Rob F - 12-19-2016, 04:10 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Robo-Tank Hardware Expansions Coming Soon | Rob F | 13 | 8,555 |
11-10-2019, 01:36 PM Last Post: Rob F |
|
| Robo-Tank 3rd Generation Hardware | Rob F | 42 | 35,411 |
06-24-2018, 07:14 PM Last Post: Rob F |
|
| Planning Final Hardware Phase | Rob F | 27 | 27,869 |
12-05-2015, 06:22 PM Last Post: Rob F |
|