How would I setup a flood sensor to turn off equipment and alert? I have a basic one from an arduino kit with a +-S, I connected to a sensor input with pull up.
I was able to set it up as an ATO and its working. That accomplishes alerts, but what about shutting off other equipment?
How would I actually go about setting this up in the UI?
Side question, anything I select in the capabilities section does not save. I select/unselect anything hit update, refresh, goes back to old values.
I was able to set it up as an ATO and its working. That accomplishes alerts, but what about shutting off other equipment?
How would I actually go about setting this up in the UI?
Side question, anything I select in the capabilities section does not save. I select/unselect anything hit update, refresh, goes back to old values.
