Flood Sensor - Printable Version +- Robo-Tank DIY Aquarium Controller Forum (https://www.robo-tank.ca/forum) +-- Forum: Robo-Tank (https://www.robo-tank.ca/forum/forum-1.html) +--- Forum: DIY Hardware Questions (https://www.robo-tank.ca/forum/forum-3.html) +--- Thread: Flood Sensor (/thread-1762.html) |
Flood Sensor - mginster - 11-01-2022 How would I setup a flood sensor to turn off equipment and alert? I have a basic one from an arduino kit with a +-S, I connected to a sensor input with pull up. I was able to set it up as an ATO and its working. That accomplishes alerts, but what about shutting off other equipment? How would I actually go about setting this up in the UI? Side question, anything I select in the capabilities section does not save. I select/unselect anything hit update, refresh, goes back to old values. RE: Flood Sensor - Rob F - 11-02-2022 Hi, I see you got an answer on reef2reef, the macros should allow this. |