Hey guys and gals. New owner of a Robo-tank here and need a bit of assistance. I am having a little trouble declaring pwm jacks on the Reef-Pi. Under connections tab when trying to declare Jacks as outputs. I get unknown pwm port error from channel 2. channel 1 is working even though I have not tested the output. What is the pin-out of the PWM ports on the Robo-tank?
Lets say I want to declare PWM1 as channel 1 of the robo tank hardware PWM2 as channel 2 etcc.
Lets say I want to declare PWM1 as channel 1 of the robo tank hardware PWM2 as channel 2 etcc.
