Hi all:
I started working on further enhancements to the UI and encountered a problem. It seems that the dosing pumps functionality is not working right, particularly after the pull requests that have been merged since the last official release (4.1). I found that the doser pump calibration dialog did not work. Moreover, I also found that the duration of the pump on-time is only a few seconds and nowhere near what I set up (e.g. 2 minutes). I reported this to upstream but have not received a reply yet.
I would appreciate if y'all (who are controlling dosing pumps) would let me know:
1) whether your setup is working or not,
2) the software version you're using,
3) the particular hardware settings (ports/jacks/etc.) you're using, and
4) any other information that would help me figure out what's going on.
Thank you all for your assistance.
Regards,
I started working on further enhancements to the UI and encountered a problem. It seems that the dosing pumps functionality is not working right, particularly after the pull requests that have been merged since the last official release (4.1). I found that the doser pump calibration dialog did not work. Moreover, I also found that the duration of the pump on-time is only a few seconds and nowhere near what I set up (e.g. 2 minutes). I reported this to upstream but have not received a reply yet.
I would appreciate if y'all (who are controlling dosing pumps) would let me know:
1) whether your setup is working or not,
2) the software version you're using,
3) the particular hardware settings (ports/jacks/etc.) you're using, and
4) any other information that would help me figure out what's going on.
Thank you all for your assistance.
Regards,
José
Please post questions in the forum (not via PM) so that everyone can benefit from and contribute to finding solutions. Thank you.
Please post questions in the forum (not via PM) so that everyone can benefit from and contribute to finding solutions. Thank you.