02-04-2021, 04:13 PM
(02-01-2021, 05:46 PM)Rob F Wrote: Sorry I'm not sure what's going wrong. I think you might have problem with sub macros, the water change turns on DC port 7 and then immediately after the Stop pumpe macro turns it off. It's a good idea to write a very basic macro to get the sensor and equipment working together than try and bring it all together. Also remember the "reverse" setting on the connectors page for the sensors and ports. If you change that always go to admin subtab and press reload button so reef-pi updates, anything you change on configuration tab requires a reload button press after.Can someone help me how to set a high level, I can't create it as I wrote