08-18-2020, 04:19 AM
(This post was last modified: 08-18-2020, 04:28 AM by kooibosmania.)
hi guys,
I hope someone can help me. I have rodi water tank and 2 float switches one for low and one for full. connected to the tank is an ato system. To fill the main display i used robotank( the old one) to switch a water relais that was connected to the rodi filters. So i automated the filling of the rodi tank. The old equipmemt i replaced with the reef pi vers a. Now what i try in ato or macro, i cant get the floats to switch the relais. In equipement the relais switches fine on hand. Has anyone have same setup ? The float dipswitches both are on other.
Regards edwin
@Rob i mailed u with this question but posted it here for the community i stil am stumped
I hope someone can help me. I have rodi water tank and 2 float switches one for low and one for full. connected to the tank is an ato system. To fill the main display i used robotank( the old one) to switch a water relais that was connected to the rodi filters. So i automated the filling of the rodi tank. The old equipmemt i replaced with the reef pi vers a. Now what i try in ato or macro, i cant get the floats to switch the relais. In equipement the relais switches fine on hand. Has anyone have same setup ? The float dipswitches both are on other.
Regards edwin
@Rob i mailed u with this question but posted it here for the community i stil am stumped